3 - 28
INSP
ADJ
FRONT BRAKE PAD INSPECTION AND REPLACEMENT
●
Loosen the pad pin
2
.
●
Remove the brake hose holder
3
and
brake caliper
4
from the front fork.
●
Remove the pad pin and brake pads
5
.
●
Connect the transparent hose
6
to the
bleed screw
7
and place the suitable con-
tainer under its end.
●
Loosen the bleed screw and push the
brake caliper piston in.
CAUTION:
Do not reuse the drained brake fluid.
●
Tighten the bleed screw.
T
R
.
.
Bleed screw:
6 Nm (0.6 m • kg, 4.3 ft • lb)
●
Install the brake pads
8
and pad pin.
NOTE:
●
Install the brake pads with their projec-
tions
a
into the brake caliper recesses
b
.
●
Temporarily tighten the pad pin at this
point.
●
Install the brake hose holder
9
and brake
caliper
0
and tighten the pad pin
A
.
NOTE:
Fit the brake hose holder cut
c
over the
projection
d
on the front fork and clamp the
brake hose.
T
R
.
.
Bolt (brake caliper):
23 Nm (2.3 m • kg, 17 ft • lb)
Pad pin:
18 Nm (1.8 m • kg, 13 ft • lb)
