3 - 24
CHK
ADJ
CHANGING THE COOLANT
b. When coolant begins to flow out of the bolt
hole, tighten the water pump air bleed bolt
to specification.
c. Loosen the thermostat cover air bleed bolt
2
, without removing it, to allow all of the air
to escape from the air bleed bolt hole.
d. When coolant begins to flow out of the bolt
hole, tighten the thermostat cover air bleed
bolt to specification.
▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲▲▲
15.Start the engine, warm it up for ten minutes,
and then rev the engine five times.
16.Pour the recommended coolant into the
radiator until it is full.
17.Stop the engine and allow it to cool. If the
coolant level has dropped after the engine
has cooled, add sufficient coolant until it
reaches the top of the radiator, and then
install the radiator cap.
18.Start the engine, and then check for coolant
leakage.
19.Install:
• fuel tank
Refer to “FUEL PUMP AND FUEL TANK” in
chapter 6.
• rear console
• seats
Refer to “SEATS, REAR CONSOLE AND
INSTRUMENT PANELS” in chapter 8.
T
R
.
.
Water pump air bleed bolt
10 Nm (1.0 m · kg, 7.2 ft · lb)
T
R
.
.
Thermostat cover air bleed bolt
10 Nm (1.0 m · kg, 7.2 ft · lb)
2
