Yamaha XVS950CU 2014, Service Manual, Page: 257 / 580

ABS (ANTI-LOCK BRAKE SYSTEM) (for ABS models)
4-66
6. Connect:
• ABS ECU coupler “1”
TIP
• Connect the ABS ECU coupler, and then push
the lock lever “a” of the coupler in the direction
of the arrow shown.
• Make sure that the ABS ECU coupler is con-
nected in the correct position as shown in illus-
tration “A”.
7. Fill:
• Brake master cylinder reservoir
• Brake fluid reservoir
(with the specified amount of the specified
brake fluid)
WARNING
EWA13090
• Use only the designated brake fluid. Other
brake fluids may cause the rubber seals to
deteriorate, causing leakage and poor
brake performance.
• Refill with the same type of brake fluid that
is already in the system. Mixing brake fluids
may result in a harmful chemical reaction,
leading to poor brake performance.
• When refilling, be careful that water does
not enter the brake fluid reservoir. Water
will significantly lower the boiling point of
the brake fluid and could cause vapor lock.
NOTICE
ECA13540
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean up
any spilt brake fluid immediately.
8. Bleed:
• Brake system
Refer to “BLEEDING THE HYDRAULIC
BRAKE SYSTEM (for ABS models)” on page
3-13.
9. Check the operation of the hydraulic unit ac-
cording to the brake lever and the brake ped-
al response. (Refer to “HYDRAULIC UNIT
OPERATION TESTS” on page 4-67.)
NOTICE
ECA14770
Always check the operation of the hydraulic
unit according to the brake lever and the
brake pedal response.
10.Delete the fault codes. (Refer to “[B-3] DE-
LETING THE FAULT CODES” on page
7-145.)
11.Perform a trial run. (Refer to “CHECKING
THE ABS WARNING LIGHT” on page 4-70.)
A. The ABS ECU coupler is connected correctly.
1 2 b
3
4
c
a
1
a
A B
B. The ABS ECU coupler is not connected.
Specified brake fluid
DOT 4