Yamaha XVS950CU 2014, Service Manual

Page: 137 / 580

CABLE ROUTING (for ABS models)
2-94
1. Right handlebar switch lead
2. Left handlebar switch lead
3. Front wheel sensor lead
4. Front wheel sensor coupler holder
5. Main switch lead
6. Fuel pump lead
7. Main switch coupler
8. Rear cylinder injector lead
9. Front cylinder injector coupler
10. ISC (idle speed control) unit coupler
11. Engine temperature sensor coupler
12. Right handlebar switch coupler
13. Immobilizer unit lead
A. Route the right handlebar switch lead through the
cable guide.
B. Route the left handlebar switch lead to the outside
of the cable guide.
C. Insert the projection on the left handlebar switch
lead holder into the hole in the cable guide.
D. Secure the plastic locking tie by inserting the
projection on the tie into the hole in the front wheel
sensor coupler holder, and then fasten the front
wheel sensor lead at the white tape with the tie.
Cut off the excess end of the plastic locking tie.
E. After connecting the front wheel sensor coupler, fit
the coupler into the slot in the front wheel sensor
coupler holder.
F. Route the front wheel sensor lead to the outside of
the engine bracket (front upper side).
G. Route the fuel pump lead to the outside of the
main switch leads and immobilizer unit lead, and
then fasten the fuel pump lead with the holder.
H. Fasten the main switch couplers to the engine
bracket (front upper side) with the plastic band. Be
sure to position the smaller coupler above the
larger coupler.
I. After connecting the immobilizer unit coupler,
insert the projection on the coupler into the hole in
the frame.
J. Connect the rear cylinder injector coupler, which
has white tape on the lead, to rear cylinder injector.
K. After connecting the engine temperature sensor
coupler, cover the coupler with the coupler cover.
L. To the fuel pump
M. Route the right handlebar switch lead under the
engine bracket (front upper side).
N. Install the right handlebar switch coupler (4-pin)
onto the tab on the engine bracket (front upper
side) and insert the projection on the right
handlebar switch coupler (8-pin) into the hole in the
bracket.
O. Route the main switch lead and immobilizer unit
lead between the right handlebar switch leads and
the engine bracket (front upper side).
P. Insert the projection on the right handlebar switch
lead holder into the hole in the cable guide.