3-29
CHK
ADJ
BLEEDING THE HYDRAULIC BRAKE SYSTEM /
ADJUSTING THE SHIFT PEDAL/
ADJUSTING THE DRIVE CHAIN SLACK
WARNING
a
b
NOTE:
CAUTION:
Bleed screw
6 Nm (0.6 m
S
kg)
k. Fill the reservoir to the proper level.
Refer to “CHECKING THE BRAKE FLUID
LEVEL”.
After bleeding the hydraulic brake system,
check the brake operation.
EAS00136
ADJUSTING THE SHIFT PEDAL
1. Check:
S
shift pedal position
The end
1
of the shift pedal is above the shift
rod. (The angle
a
should be approximately
90
_
.)
Incorrect
Adjust.
2. Adjust:
S
shift pedal position
a. Loosen both locknuts
2
.
b. Turn the shift rod
3
in direction
a
or
b
to
obtain the correct shift pedal position.
Direction
Shift pedal is raised.
Direction
Shift pedal is lowered.
S
Tighten both locknuts.
EAS00140
ADJUSTING THE DRIVE CHAIN SLACK
The drive chain slack must be checked at the
tightest point on the chain.
A drive chain that is too tight will overload
the engine and other vital parts, and one that
is too loose can skip and damage the swin-
garm or cause an accident. Therefore, keep
the drive chain slack within the specified
limits.
Summary of Contents for XJR1300(L) 99
