Yamaha XJR1300(L) 99, Service Manual

Page: 52 / 338

2-32
J Position the seat lock cable in-
side under the seat lock bracket.
K Fasten the wireharness to the
frame with a plastic band. Make
sure that the end of band down
ward.
L Route the starter cable between
the throttle cables.
M Fasten the wireharness, starter
cable to the frame with a plastic
band. Make sure that end of ba-
nd down ward.
G Fasten the battery positive (+)
lead and battery positive (+) lead
connector on the groove of the
battery with the battery rubber
band.
H Position the starter motor cable
at 45 degree out side of the mo-
torcycle.
I Position the wireharness, tail-
light lead and rear turn signal
light leads (left and right) be-
tween the taillight bracket and
rear fender rib.
E Connect the fuel sender connec-
tor, neutral switch connector,
pickup coil connector and side-
stand switch connector above
the air filter case.
F Route the battery negative (–)
lead inside of the reservoir tank
bracket and under the reservoir
tank and then connect it.
SPEC
CABLE ROUTING