Yamaha Waverunner VXS VX1800, Service Manual

Page: 283 / 318

RiDE motor
8-30
TIP:
Align the mark “a” on the rubber hose “3” with
the mark “b” on the water tank “1”.
14. Install the rubber hose “1”, and then tight-
en the rubber hose clamps “2” and “3” to
the specified torque.
TIP:
Align the protrusion “a” on the rubber hose “1”
with the mark “b” on the water tank “4”.
15. Install the resonator “5”, and then tighten
the clamp “6” to the specified torque.
TIP:
Fit the protrusion “c” on the resonator “5” be-
tween the protrusions “d” on the rubber hose
“1”.
16. Connect the RiDE motor couplers “a” and
“b”, and then fasten the RiDE motor lead
using a plastic tie “1”.
17. Install the deck beam “1”, and then tighten
the deck beam nut “2” to the specified
torque.
18. Initialize the RiDE system using the YDIS.
See “YDIS Instruction Manual”.
RiDE system initialization
Connect the YDIS and initialize the RiDE sys-
tem. See “YDIS Instruction Manual”.
Rubber hose clamp “2”
3.5 Nm (0.35 kgf·m, 2.58 ft·lb)
Rubber hose clamp “2”, “3”, and “6”
3.5 Nm (0.35 kgf·m, 2.58 ft·lb)
2
1
3
a
b
1
5
4
3
6
2
a
b
d
c
Deck beam nut “2”
16 Nm (1.6 kgf·m, 11.8 ft·lb)
b
a
1
1
2
LT
271