Yamaha TMAX XP530E-A 2017, Service Manual

Page: 89 / 676

CABLE ROUTING
2-42
1. Centerstand lock solenoid coupler
2. Centerstand lock solenoid lead
3. Sidestand switch
4. Sidestand switch lead
5. Starter motor lead
6. Plastic locking tie
7. Footboard
8. Joint coupler lead
9. Wire harness (seat/fuel lid lock solenoid lead)
10.Rear frame
11.Wire harness
12.Generator cover protector
13.Centerstand lock solenoid cover
A. Install the wire harness clamp into the hole
on the fuel tank bracket.
B. Install the plastic locking tie within this range.
C. Install the plastic locking tie so that the cen-
terstand lock solenoid lead does not go slack
in the space between the centerstand lock
solenoid coupler and the guide of the genera-
tor cover protector.
D. Make sure that the centerstand lock solenoid
lead does not slacken in this range.
E. Install the centerstand lock solenoid lead to
the rib of the generator cover protector. (3
locations)
F. Anti-theft alarm coupler (no connection)
G. Install the clamp of the sidestand switch lead
to the bracket.
H. To the tracking system control unit (except for
XP530E-A)
I. Fasten the wire harness to the footboard with
the plastic locking tie. Position the plastic
locking tie within the range shown in the illus-
tration. Point the end of the plastic locking tie
rearward and place it inside of the footboard.
J. Install the wire harness clamp into the hole in
the rear frame.
K. Route the seat/fuel lid lock solenoid lead
through the rib portion of the filler cover.
L. The end of the plastic locking tie should face
the inside without being cut.
M. Route the centerstand lock solenoid lead
through the notch section of the centerstand
lock solenoid cover.
N. Install the plastic locking tie between the wire
harness clamp and the centerstand lock sole-
noid coupler. Make sure the plastic locking tie
does not come into contact with the bare
wire. The end of the plastic locking tie should
face downward without being cut.
O. Fasten the white tape section of the starter
motor lead with the plastic locking tie.
P. Connect the fuel pump coupler securely to
the fuel pump.