En
124
■
Network
Displays the network information on this unit.
■
System
Displays the system information on this unit.
• If this unit detects a newer firmware over the network, “!” (exclamation mark) appears at the upper right of
the “Information” and “System” icons, and the corresponding message will be displayed in this screen. You
can update the firmware of this unit by pressing ENTER in this screen and following the procedure in
“Updating the firmware of this unit” (p.137).
■
Zone
Displays information about Zone2 and Zone3.
You can configure the system settings of this unit using the front display.
1
Set this unit to standby mode.
2
While holding down STRAIGHT on the font panel, press MAIN ZONE
.
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press MAIN ZONE
to set this unit to standby mode and turn it on
again.
The new settings become effective.
IP Address
IP address
Subnet Mask
Subnet mask
Default Gateway
The IP address of the default gateway
DNS Server (P)
The IP address of the primary DNS server
DNS Server (S)
The IP address of the secondary DNS server
MAC Address
MAC address
Status
Network connection status
Remote ID
The remote control ID setting of the main unit (p.125)
TV Format
The video signal type setting of this unit (p.126)
Speaker Impedance
The speaker impedance setting of this unit (p.125)
System ID
System ID number
Firmware Version
The version of firmware installed on this unit
Input
The input source selected for Zone2 or Zone3
Volume
The volume setting for Zone2 or Zone3
Configuring the system settings
(ADVANCED SETUP menu)
MAIN ZONE
PROGRAM
STRAIGHT
