Yamaha NUAGE, Setup Manual

Page: 84 / 159

84
6. Starting up & equipment settings
6-1. Sequence for equipment start-up
To avoid any hearing damage caused by loud noises when turning on equipment, follow the
sequence shown below for starting up Nuage and other equipment.
1. Nuage controller (Nuage Fader/Nuage Master)
2. Computer monitors and computer peripherals
3. Computers
4. Video equipment, SyncStation, outboard gear
5. Nuage I/O
6. NUENDO
7. Powered speakers (or power amp)
When shutting off power, reverse the above order.
1. Powered speakers (or power amp)
2. NUENDO
3. Nuage I/O
4. Video equipment, SyncStation, outboard gear
5. Computers, computer monitors, and computer peripherals
6. Nuage controller (Nuage Fader/Nuage Master)
6-2. Starting up controller
Switch on the Nuage Fader/Nuage Master, in any order.
Tip:
The Nuage Controller has an “all-lit” mode for operational checks; when started up in “all-lit”
mode, all buttons, LEDs, and other visual-feedback elements will be lit at maximum power.
Holding down the DAW “A” and “B” buttons when turning it on and continuing to press them will
put it into “all-lit” mode. To return it to normal mode, turn it off and back on again.