ELECTRICAL COMPONENTS
9-92
b. Measure the crankshaft position sensor re-
sistance.
▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲▲▲
EAS28130
CHECKING THE LEAN ANGLE SENSOR
1. Remove:
• Lean angle sensor
2. Check:
• Lean angle sensor output voltage
Out of specification
→
Replace.
▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼▼▼
a. Connect the lean angle sensor coupler to the
wire harness.
b. Connect the pocket tester (DC 20 V) to the
lean angle sensor coupler as shown.
c. Set the main switch to “ON”.
d. Tilt the lean angle sensor to 65°.
e. Measure the lean angle sensor output volt-
age.
▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲▲▲
EAS28940
CHECKING THE STARTER MOTOR
OPERATION
1. Check:
• Starter motor operation
Does not operate
→
Perform the electric
starting system troubleshooting, starting with
step 4.
Refer to “TROUBLESHOOTING” on page
9-9.
▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼▼▼
a. Connect the positive battery terminal “1” and
starter motor lead “2” with a jumper lead “3”.
WARNING
EWA13810
• A wire that is used as a jumper lead must
have at least the same capacity of the bat-
tery lead, otherwise the jumper lead may
burn.
• This check is likely to produce sparks,
therefore, make sure no flammable gas or
fluid is in the vicinity.
b. Check the starter motor operation.
▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲▲▲
EAS28150
CHECKING THE STATOR COIL
1. Disconnect:
• AC magneto coupler
(from the wire harness)
2. Check:
• Stator coil resistance
Out of specification
→
Replace the crank-
shaft position sensor/stator assembly.
▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼▼▼
a. Connect the pocket tester (
Ω
×
1) to the AC
magneto coupler as shown.
Lean angle sensor output voltage
Less than 65°: 3.55–4.45 V
More than 65°: 0.65–1.35 V
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe
yellow/green “1”
• Negative tester probe
black/blue “2”
Gy
B
1
2
UP
L Y
/
G B
/
L
65˚
65˚
1
2
Stator coil resistance
0.108–0.132
Ω
at 20 °C (68 °F)
R
/
W
R
/
Y
L
/
Y
Br
/
B
techsparkstudio.com
Summary of Contents for Grizzly550
