• 10: Flt EGDepth (only available when Filter Sw “on”)
❑
Filter EG Depth
❑
-64 … +63
The “FiltEGDept” parameter determines to what degree the envelope generator (page 56) affects the filter’s cutoff
frequency. Higher values allow the envelope generator to vary the filter cutoff frequency over a wider range. This
parameter offsets the value of the EDIT [VOICE] mode COMMON/Filter/EG Depth parameter.
• 11: LFO2 Speed (only available when Filter Sw “on”)
❑
LFO2 Speed
❑
Settings: -64 … +63
LFO2 (Low Frequency Oscillator 2) is used primarily for filter modulation, and thus to produce “wow” type effects.
The “LFO2 Speed” parameter sets the speed of the effect. Positive values produce a faster effect, while negative
values produce a slower effect. This parameter offsets the value of the EDIT [VOICE] mode COMMON/LFO2/Speed
parameter.
• 12: LFO2 FltMod (only available when Filter Sw “on”)
❑
LFO2 Filter Modulation
❑
Settings: -64 … +63
Sets the amount of LFO 2 filter modulation applied by the modulation controller (e.g. the modulation wheel on a
keyboard). The higher the value the greater the amount of filter modulation produced by modulation controller
operation. This parameter offsets the value of the EDIT [VOICE] mode COMMON/LFO2/FilterModDpt parameter.
EG (Envelope Generator)
• 01: Attack Time
❑
Envelope Generator Attack Time
❑
Settings: -64 … +63
Sets the attack time of the amplitude/filter envelope generator. “Attack time” refers to the length of time it takes for
the envelope to reach maximum level from the instant a note is played. Positive values produce a slower attack while
negative values produce a faster attack. Please note that positive values only affect carrier attack time. This
parameter offsets the value of the EDIT [VOICE] mode COMMON/Filter/EG Time1 parameter. (page 56) and the
EDIT [VOICE] /OPERATOR/EG/Time1 parameter (page 66).
• 02: Decay Time
❑
Envelope Generator Decay Time
❑
Settings: -64 … +63
Sets the decay time of the amplitude/filter envelope generator. “Decay time” refers to the length of time it takes for
the envelope to fall to the sustain level after the maximum attack level has been reached. Positive values produce a
slower decay while negative values produce a faster decay. This parameter offsets the value of the EDIT [VOICE]
mode COMMON/Filter/EG Time2, EG Time3 parameters, and EDIT [VOICE] mode OPERATOR/EG/Time2, Time3.
• 03: ReleaseTime
❑
Envelope Generator Release Time
❑
Settings: -64 … +63
Sets the release time of the amplitude/filter envelope generator. “Release time” refers to the length of time it takes for
the envelope to fall to “zero” level after the note has been released. Positive values produce a slower release while
negative values produce a faster release. This parameter offsets the value of the EDIT [VOICE] mode
COMMON/Filter/EG Time4 parameter, and EDIT [VOICE] mode OPERATOR/EG/Time4.
39
2/FS1R/EDIT/E.qx 10/19/98 7:23 PM Page 39
Summary of Contents for FS1R
Page 1: ...OWNER S MANUAL ...
Page 87: ...3 FS1R UTILITY E qx 10 20 98 1 17 PM Page 87 ...