Yamaha FS1R, Owner'S Manual

Page: 30 / 88

30
EDIT [PERFORMANCE]
COMMON
The COMMON group provides access to a range of parameters which mostly affect all parts of performance setup.
They are thus “common” to all parts.
Parameter Sub-Group Parameter Page
• CtrlSrc • VC1 by KN1 … VC8 by PB 30
• CtrlDst • VC1 Part 1 … VC8 Part 4 31
• Fseq • Part 32
• Fseq Assign 32
• Play Mode 33
• Key On Trigger 33
• Play Speed Ratio 33
• Speed Velocity Sensitivity 33
• Level Velocity Sensitivity 33
• Pitch Mode 34
• Start Delay 34
• Start Offset 34
• Loop Mode 34
• Loop Start 34
• Loop End 35
• Others • Individual Output 35
• Performance Category 36
• Performance Name 36
CtrlSrc (Control Source)
One of the most powerful features of the FS1R controller system is the ability to create “voice control sets” for
realtime performance control. Up to 8 voice control sets - “VC1” through “VC8” - can be created for each
performance setup. Each set allows any or all of the “source” controllers to be assigned to one of the available
“destination” parameters (specified in the “CtrlDst” function, below), and control of each performance part can be
turned on or off as required.
A voice controller set can, for example, assign a single controller such as Knob 1 or a Foot Controller to a single
parameter such as, say, LFO speed. Or it could assign a number of controllers to the same parameter: Knob 1, a
Foot Controller, and a Modulation wheel, for example could all be assigned to control LFO speed. On the other
hand, the same controller can be assigned to control different parameters in different control sets, so you end up
with a single controller controlling up to 8 different parameters at the same time!
Display Abbreviation Source Controller
KN1 … KN4
MC1 … MC4
Knob 1 through Knob 4. MIDI control change numbers can be assigned to each knob via the UTILITY mode SYSTEM/Control
parameters (page 74).
MIDI Control 1 through MIDI Control 4.
These are assignable MIDI control change messages, the MIDI control change numbers of which can be specified via the UTILITY
mode SYSTEM/Control parameters (page 74).
FC
BC
Foot Controller. MIDI control change numbers can be assigned to foot control via the UTILITY mode SYSTEM/Control parameters
(page 74).
The available source controllers are:
Breath Controller. MIDI control change numbers can be assigned to breath control via the UTILITY mode SYSTEM/Control
parameters (page 74).
Modulation Wheel
Channel Aftertouch
Polyphonic Aftertouch (handled the same way as Channel Aftertouch on the FS1R)
Pitch Bend Wheel
MW
PAT
CAT
PB
2/FS1R/EDIT/E.qx 10/19/98 7:22 PM Page 30