31
In the CtrlSrc parameter group you can turn any of the available source controllers on or off for any of the 8 voice
control sets: “VC1” through “VC8.” The CURSOR [
] and [
] buttons individually select the full range of voice set
and controller combinations. For example, when “VC1 by KN3” is “on”, Knob 3 is assigned to control whichever
destination parameter and parts and assigned to voice control set 1 (“VC1”) via the CtrlDst parameters, below.
Or if “VC6 by FC” is “on”, then a Foot Controller is assigned to whichever destination parameter and parts and
assigned to voice control set 6 (“VC6”) via the CtrlDst parameters.
The PART [
] and [
] buttons can be used to switch directly to different voice control sets: e.g. VC1
→
VC2
→
VC3, etc. The VALUE [
] and [
] buttons turn the selected “VC by controller” assignment on or off. Knob 1 can
also be used to select different voice control sets when the knob LED is not lit.
CtrlDst (Control Destination)
The CtrlDst parameters specify the parts to be controlled by the voice control sets defined in the CtrlSrc parameters,
above, and the parts to be controlled. In the CtrlDst parameter group the following parameters are available for each
voice set, where the “n” in “VCn” is a number from 1 to 8 (i.e. “VC1” through “VC8”), and “***” is a parameter name:
Parameter
Settings
Effect
VCn = ***
(Control Destination)
VCn Depth
Specifies the parameter to be controlled by the corresponding
voice control set.
Please note that when “off”, any of the insertion effect parameters,
“Fseq Speed”, or “Fseq Scratch” are selected the VCn Part1
through Part4 parameters are not available.
A range of controllable parameters, including a number of insertion
effect parameters. The parameters are listed in the separate “Data
List” booklet. The available insertion effect parameters will depend
on the selected insertion effect type (page 47).
Sets the depth of control which can be applied via the
corresponding voice control set. Higher values allow greater
(deeper) control. With a setting of “+63”, for example, 100% depth
will be produced with the assigned controller at the halfway
position. A setting of “+31” produces 100% depth at the maximum
controller settings.
-64 … +63
VCn Part1
When “on”, the correspondingly numbered voice controller set is
assigned to part 1.
on, off
VCn Part2
When “on”, the correspondingly numbered voice controller set is
assigned to part 2.
on, off
VCn Part3
When “on”, the correspondingly numbered voice controller set is
assigned to part 3.
on, off
VCn Part4
When “on”, the correspondingly numbered voice controller set is
assigned to part 4.
on, off
2/FS1R/EDIT/E.qx 10/19/98 7:23 PM Page 31
Summary of Contents for FS1R
Page 1: ...OWNER S MANUAL ...
Page 87: ...3 FS1R UTILITY E qx 10 20 98 1 17 PM Page 87 ...
