• 02: Feedback
❑
Feedback
❑
Settings: 0 … 7
Sets the amount of feedback applied to the feedback operator in the currently selected algorithm. Higher values
apply a greater amount of feedback. The operator to which feedback can be applied in the selected algorithm is
indicated at the bottom of the display by “FBOP” followed by the number of the operator. An indication such as
“FB3-5” in the same location means that feedback is applied from the output of operator 5 to the input of operator 3.
“FB—” means that there is no feedback in the current algorithm.
• 03: NoteShift
❑
Note Shift
❑
Settings: -24 … +24
Transposes the pitch of the current voice down or up in semitone steps over a ±2 octave range. “0” corresponds to
standard pitch. Each increment corresponds to a semitone. A setting of “-12”, for example, transposes the pitch
down one octave.
• 04 … 08: FORMANT 1 … 5
❑
Formant Control 1 … 5
❑
Settings: (OP Type/Number) V:1 … V:8, N:1 … N:8
(Destination) off, out, freq, width
(Values) -64 … +63
These five parameter groups can be used to specify up to five operators for format control via the FORMANT knob
when the upper Knob Mode Selector is engaged. The leftmost value specifies a voiced (“V”) or unvoiced (“N”)
operator. The central value specifies the type of control (“off” = no control, “out” = operator output level, “freq” =
operator frequency, and “width” = operator bandwidth). The rightmost parameter specifies the depth of control
which can be applied via the FORMANT knob. Higher values allow greater (deeper) control. With a setting of “+63”,
for example, a maximum depth of 100% can be achieved by rotating the FORMANT knob clockwise. A setting of
“+31” allows a maximum depth of 50% to be achieved by rotating the FORMANT knob clockwise. Negative settings
reverse the effect of knob rotation.
• 09: … 13: FM 1 … 5
❑
FM Control 1 … 5
❑
Settings:
(OP Type/Number) V:1 … V:8, N:1 … N:8
(Destination) off, out, freq, width
(Values) -64 … +63
These five parameter groups can be used to specify up to five operators for FM control via the FM knob when the
upper Knob Mode Selector is engaged. The leftmost value specifies a voiced (“V”) or unvoiced (“N”) operator. The
central value specifies the type of control (“off” = no control, “out” = operator output level, “freq” = operator
frequency, and “width” = operator bandwidth). The rightmost parameter specifies the depth of control which can be
applied via the FM knob. Higher values allow greater (deeper) control. With a setting of “+63”, for example, a
maximum depth of 100% can be achieved by rotating the FM knob clockwise. A setting of “+31” allows a maximum
depth of 50% to be achieved by rotating the FM knob clockwise. Negative settings reverse the effect of knob
rotation.
59
2/FS1R/EDIT/E.qx 10/19/98 7:23 PM Page 59
Summary of Contents for FS1R
Page 1: ...OWNER S MANUAL ...
Page 87: ...3 FS1R UTILITY E qx 10 20 98 1 17 PM Page 87 ...
