Yamaha FS1R, Owner'S Manual

Page: 43 / 88

43
• 08: VelSens Dpt
❑
Velocity Sensitivity Depth
❑
Settings: 0 … 127
Determines the slope of the velocity curve. The graph at the bottom of the display indicates the current velocity
curve as determined by the “VelSensDpt” and “VelSensOfs” parameters. The horizontal axis represents keyboard
velocity and the vertical axis represents output level.
• 09: VelSens Ofs
❑
Velocity Sensitivity Offset
❑
Settings: 0 … 127
Specifies an offset value that will apply to the keyboard velocity level. The graph at the bottom of the display
indicates the current velocity curve as determined by the “VelSensDpt” and “VelSensOfs” parameters. The horizontal
axis represents keyboard velocity and the vertical axis represents output level.
• 10: ExprLimitLo
❑
Expression Low Limit
❑
Settings: 0 … 127
Specifies the lowest MIDI expression control change message which will be recognized by the FS1R, and therefore
the lowest volume level which will be produce when, for example, an expression pedal is rocked all the way
backward.
• 11: Sus Rcv Sw
❑
Sustain Receive Switch
❑
Settings: on, off
Determines whether MIDI sustain switch data will be received by the current part. The current part will respond to
sustain switch messages when this parameter is turned “on”.
• 12: Pan
❑
Pan
❑
Settings: rdm, L63 … C … R63
Sets the pan position of the current part - i.e. the position of the part between left and right in the stereo sound field.
A setting of “L63: sets the pan position full left, “Cnt” sets the pan at center, and “R63” sets the pan full right. In-
between settings produce corresponding intermediate pan positions. The “rdm” (random) setting produces a
random pan position for each note played.
• 13: Pan Scaling
❑
Pan Scaling
❑
Settings: -50 … +50
Sets panning in relation to pitch. When set to “+0” the pan position is exactly as specified by the Pan parameter,
above. Increasing positive values produce a wider pitch-based pan range, with notes lower than C3 being panned
to the left and notes higher than C3 being panned to the right of the pan position specified by the Pan parameter.
Negative values reverse the pan direction. Please note that the C3 point will shift in accordance with the settings of
the Note Shift parameters (pages 24, 40, 59, 71).
• 14: Pan Mod
❑
Pan Modulation
❑
Settings: 0 … 99
Sets the depth of pan modulation in accordance with the setting of LFO1 (Waveform, Speed, Delay, and Key Sync).
The higher the value, the greater the degree of pan modulation.
2/FS1R/EDIT/E.qx 10/19/98 7:23 PM Page 43