INSP
ADJ
BATTERY INSTALLATION
Replace the battery if:
• Battery voltage does not rise to a specific
value or bubbles fail to rise during charging.
• Sulphation of one or more cells occurs, (as
indicated by the plates turning white, or ma-
terial accumulating in the bottom of the cell ).
• Specific gravity readings after a long, slow
charge indicate that one cell is charged lower
than the rest.
• Warpage or buckling of plates or insulators is
evident.
3-29
6. Install :
• Battery
7. Connect:
• Battery leads
8. Connect :
• Breather hose
Be sure the Hose is properly attached and
routed.
Refer to “CABLE ROUTING” section in
Chapter 2, Page no 2-21
9. Install :
• Side cover (left)
Refer to “SEAT, SIDE COVERS AND
FUEL TANK” section on Page no 3-3
WARNING
CAUTION:
Always charge a new Battery completely before installing it to ensure maximum performance.
WARNING
Battery electrolyte is dangerous. It contains sulfuric acid which is poisonous and highly caustic.
Always follow these preventive measures:
• Avoid body contact with electrolyte as it can cause severe burns and permanent eye injury.
• Wear protective eye gear when handling or working near batteries.
• Antidote (EXTERNAL):
• SKIN- Flush with water for 15 minutes and get immediate medical attention.
• Antidote (INTERNAL)
• Drink large quantities of water or milk followed with milk of magnesia, beaten egg or
vegetable oil. Get immediate medical attention.
• Batteries generate explosive hydrogen gas.
• Always follow these preventive measures:
• Charge batteries away from fire, sparks or open flames (e.g., welding equipment, lighted
cigarettes, etc.)
• DO NOT SMOKE when charging or handling batteries.
• KEEP BATTERIES AND ELECTROLYTE OUT OF REACH OF CHILDREN.
WARNING
CAUTION:
Connect the positive lead ¿ first and then
connect the negative lead À
¿
À
Summary of Contents for Fazer
Page 1: ...SERVICE MANUAL ...
Page 36: ...SPEC ENGINE BEARINGS ENGINE BEARINGS 2 20 ...
Page 186: ...ELEC CIRCUIT DIAGRAM 7 1 ...