INSP
ADJ
STEERING HEAD INSPECTION
• Check the Steering Stem by Turning it Lock to
Lock. If there is any binding, remove the Steer-
ing Stem Assembly and inspect the Steering
Bearings.
Refer to “STEERING HEAD AND HANDLE-
BAR” section in Chapter 6 Page no 6-29
• Install the Damper Rubber Á and Ring Nut À
(upper), then align the slots of both Ring Nut
 (lower) and tighten the other until they are
aligned.
• Install the Lock Washer ¿
NOTE :
Make sure the lock washer tab is placed in the
slots of Ring Nut.
6. Install :
• Handle crown ¿
• Handle Crown bolt À
• Handlebar Á
• Handlebar upper holder  - 2 Nos
• Bolts (handlebar upper holders) Ã-4 Nos.
• Bands Ä - 2 Nos.
3-23
WARNING
Avoid over torquing.
Ring nut-lower (final tightening) :
23 Nm (2.3 m.kg, 17 ft. lb)
Bolts (handle crown and inner tube)
23 Nm (2.3 m.kg, 17 ft.lb)
Bolt (handle crown and Steering
Shaft )
35 Nm (3.5 m. kg, 25 ft.lb)
Bolts (handlebar upper holder)
23 Nm (2.3 m. kg, 17 ft. lb)
NOTE :
Set the Torque Wrench to the Ring Nut Wrench
so that they form a right angle.
À
Â
Ã
Ä
¿
Á
Summary of Contents for Fazer
Page 1: ...SERVICE MANUAL ...
Page 36: ...SPEC ENGINE BEARINGS ENGINE BEARINGS 2 20 ...
Page 186: ...ELEC CIRCUIT DIAGRAM 7 1 ...
