Yamaha Fazer, Service Manual

Page: 10 / 213

GEN
INFO
IMPORTANT INFORMATION
1-3
WARNING
If the Circlip is fitted the wrong way it would
cause it to jump off its groove and damage
related components.
WARNING
CAUTION:
Do not use compressed air to spin the
Bearings dry. This causes damage to the
Bearing surfaces.
ALL REPLACEMENT PARTS
1. Use only genuine Yamaha parts for all
replacements. Use Yamalube Oil and
Grease recommended by Yamaha for
assembly and adjustment. Other brands
may be similar in function and appearance,
but inferior in quality.
GASKETS, OIL SEALS, AND O-RINGS
1. All Gaskets, Seals and O-rings should be
replaced when the Engine is overhauled.
2. All surfaces where Gasket, Oil Seal lips and
O-rings contact must be cleaned and
Lubricated.
LOCK WASHERS/PLATES AND COTTER
PINS
1. All Lock Washers/plates ¿ and Cotter Pins
must be replaced when they are removed.
Lock tab (s) should be bent along the Bolt
BEARINGS AND OIL SEALS
1. Install the bearing (s) ¿ and Oil Seal (s)
À with their manufacturer’s marks or
numbers facing outward. (In other words,
the stamped letters must be on the side
exposed to view.) When installing Oil Seal
(s), lubricate a light coating of lightweight
lithium base grease to the seal lip(s). Oil the
Bearings liberally when installing.
CIRCLIPS
1. All Circlips should be inspected carefully
before reassembly. Always replace Piston
Pin Clips after one use. Replace distorted
Circlips. When installing a circlip ¿, make
sure that the sharp-edged corner À is
positioned opposite to the thrust Á it
receives. See the sectional view of shaft Â.