ELEC
7. RECTIFIER CUM REGULATOR UNIT
• Check the Charging Voltage
Procedure Steps
• Connect the Tachometer to Spark plug lead
• Connect the Multimeter ( DC 20V) to Bat-
tery Red Wire.
Measure the Battery Voltage : 12V
If less than specifications, charge the
Battery
• Start the engine and accelearte the Engine
up to 5000 RPM .
• Check the Charging voltage :
Charging voltage :
14 ~ 15 V at 5000RPM
MEETS SPECIFICATIONS
Charging Circuit and Rectifier cum Regula-
tor are OK
Rectifier cum Regulator unit is faulty.
• Replace RR unit
OUT OF
SPECIFICATION
8. WIRING CONNECTIONS
• Check the connection for entire Ignition and
Charging System “REFER TO CIRCUIT
DIAGRAM” Page 7-4
POOR CONNECTIONS
Repair/ Replace the Harness
IF CORRECT
IGNITION SYSTEM / CHARGING SYSTEM
7-8
æ
10. TACHOMETER
• Check Tachometer Operation and entire
connection
IF NOT WORKING
Replace Tachometer
Multimeter (+) lead Ÿ Battery (+) terminal ¿
Multimeter (-) lead Ÿ Battery (-) terminal À
¿
À
9. CDI Unit
• Check CDI unit “REFER IGNITION
T I M I N G P R O C E D U R E C h a p t e r 3 ,
Page 3.11
Summary of Contents for Fazer
Page 1: ...SERVICE MANUAL ...
Page 36: ...SPEC ENGINE BEARINGS ENGINE BEARINGS 2 20 ...
Page 186: ...ELEC CIRCUIT DIAGRAM 7 1 ...
