CHAS
1
2
STEERING HEAD AND HANDLEBAR
STEERING INSPECTION
1. Wash the Bearing and Ball Races with a sol-
vent
2. Inspect :
• Bearing Races ¿
• Ball Cage Bearing À
Pitting/Damage Ÿ Replace
ææææææææææææææææææææææææææææææææææ
Bearing Race replacement steps :
• Remove the Ball Races on the Head Pipe us-
ing Long Rod ¿ and the hammer as shown
• Remove the Ball Race on the Under Bracket
using the floor chisel À and the hammer as
shown
• Install the new Dust Seal and Races
ææææææææææææææææææææææææææææææææææ
NOTE :
Always replace Bearing races as a set.
STEERING INSTALLATION
Reverse the “REMOVAL”procedure
Note the following points
1. Lubricate
• Balls (upper and lower)
• Ball Races
2. Install :
• Ring Nut (lower) ¿
• Damper Rubber À
• Ring Nut (upper) Á
• Lock Washer Â
Refer to “STEERING HEAD
INSPECTION” section in Chapter 3, Page
no 3-22
3. Install :
• Bush
• Meter Assembly with Handle Crown
6-30
WARNING
CAUTION:
If Bearing Race is not fitted squarely, the
Head Pipe could be damaged.
Recommended lubricant
Lithium - soap base grease
Ring Nut:
23 Nm (2.3 m.kg, 17 ft.lb)
Summary of Contents for Fazer
Page 1: ...SERVICE MANUAL ...
Page 36: ...SPEC ENGINE BEARINGS ENGINE BEARINGS 2 20 ...
Page 186: ...ELEC CIRCUIT DIAGRAM 7 1 ...