Basic components
19
EMU26152
Power trim and tilt switch on bottom
engine cowling
The power trim and tilt switch is located on
the side of the bottom engine cowling. Press-
ing the switch “
” (up) trims the outboard
motor up, and then tilts it up. Pressing the
switch “
” (down) tilts the outboard motor
down and trims it down. When the switch is
released, the outboard motor will stop in its
current position.
WARNING
EWM01030
Use the power trim and tilt switch located
on the bottom engine cowling only when
the boat is at a complete stop with the en-
gine off. Attempting to use this switch
while the boat is moving could increase
the risk of falling overboard and could
distract the operator, increasing the risk
of collision with another boat or an obsta-
cle.
NOTE:
For instructions on using the power trim and
tilt switch, see page 49.
EMU30900
Variable trolling RPM switches
The trolling speed can be adjusted when the
outboard motor is trolling. Press the “
”
switch to increase the trolling speed and
press the “
” switch to decrease the trolling
speed.
NOTE:
●
The trolling speed changes approximately
50 r/min each time a switch is pressed.
●
If the trolling speed has been adjusted, the
engine returns to the normal trolling speed
when the engine is stopped and restarted
or when the engine speed exceeds ap-
proximately 3000 r/min.
●
For instructions on using the variable troll-
ing RPM switches, see page 45.
1. Power trim and tilt switch
UP
DN
ZMU03634
1
