![background image](http://html.mh-extra.com/html/yamaha/dm-2000-version-2/dm-2000-version-2_owners-manual_896473327.webp)
Effects Parameters
327
DM2000—Owner’s Manual
OCTA REVERB
Eight input, eight output reverb.
AUTO PAN 5.1
Six input, six output autopanner for 5.1 surround. You can reset to the pan position specified by
the OFFSET parameter by pressing the RESET button.
CHORUS 5.1
Six input, six output chorus for 5.1 surround.
Parameter
Range
Description
REV TIME
0.3–99.0 s
Reverb time
REV TYPE
Hall, Room, Stage, Plate
Reverb type
INI. DLY
0.0–100.0 ms
Initial delay before reverb begins
HI. RATIO
0.1–1.0
High-frequency reverb time ratio
LO. RATIO
0.1–2.4
Low-frequency reverb time ratio
DIFF.
0–10
Reverb diffusion (left–right reverb spread)
DENSITY
0–100%
Reverb density
E/R BAL.
0–100%
Balance of early reflections and reverb
(0% = all reverb, 100% = all early reflections)
HPF
THRU, 21.2 Hz–8.00 kHz
High-pass filter cutoff frequency
LPF
50.0 Hz–16.0 kHz, THRU
Low-pass filter cutoff frequency
Parameter
Range
Description
SOURCE
OFF, HOLD, INPUT1,
INPUT2, INPUT3,
INPUT4, INPUT5,
INPUT6, MIDI
When set to OFF, the TRIGGER button is used to start autopan.
When set to HOLD, autopan runs continuously. When set to INPUT
1–6, the specified channel’s input signal triggers autopan. When set
to MIDI, a MIDI Note On message can be used to trigger autopan.
TRIG. LVL
–60 to 0 dB
Input trigger level (i.e., the signal level required to trigger panning
when SOURCE set to INPUT)
TRG MASK
0–1000 ms
Trigger Mask specifies the time from when a trigger is received until
the next trigger will be accepted.
TIME
0.0 s–10.0 s
The time after which autopan starts once it’s been triggered
SPEED
0.05 Hz–40.00 Hz
Autopan speed
DIR.
Turn L, Turn R
Autopan direction
OFFSET
–180 to +180 degrees
Pan offset
HPF
THRU, 21.2 Hz–8.00 kHz
High-pass filter cutoff frequency
LPF
50.0 Hz–16.0 kHz, THRU
Low-pass filter cutoff frequency
Parameter
Range
Description
FREQ.
0.05–40.00 Hz
Modulation speed
AM DEPTH
0–100%
Amplitude modulation depth
PM DEPTH
0–100%
Pitch modulation depth
MOD. DLY
0.0–400.0 ms
Modulation delay time
WAVE
Sine, Tri
Modulation waveform
HPF
THRU, 21.2 Hz–8.00 kHz
High-pass filter cutoff frequency
LPF
50.0 Hz–16.0 kHz, THRU
Low-pass filter cutoff frequency
SYNC
OFF/ON
Tempo parameter sync on/off
NOTE
1
1.
Used in conjunction with TEMPO to determine FREQ.