PREPARATIONS
➤
Optimizing the speaker settings automatically (YPAO)
En
53
Measuring at multiple listening positions
(multi measure)
When “Multi Position” is set to “Yes”, follow the procedure below for
measurement. It takes about 15 minutes to measure 8 listening
positions.
• If any error message (such as E-1) or warning message (such as W-1) appears,
see “Error messages” (p.57) or “Warning messages” (p.58).
• (RX-A3040 only)
Do not use the microphone base until the corresponding message appear on the
TV.
1
To start the measurement, use the cursor keys to
select “Measure” and press ENTER.
The measurement will start in 10 seconds. Press ENTER
again to start the measurement immediately.
• To cancel the measurement temporarily, press RETURN.
The following screen appears on the TV when the
measurement at the first position finishes.
2
Move the YPAO microphone to the next listening
position and press ENTER.
Repeat Step 2 until measurements at all listening positions
(up to 8) have been taken.
3
When the measurements at the positions you want
to measure are completed, use the cursor keys to
select “CANCEL” and press ENTER.
When you have taken measurements at 8 listening
positions, the following screen appears automatically.
(RX-A2040)
(RX-A3040 [when angle/height measurement is disabled])
Proceed to Step 5.
(RX-A3040 [when angle/height measurement is enabled])
Proceed to Step 4.
ENTER
RETURN
1 2 3 4 5 6 7 8 9 10
Cursor keys
Summary of Contents for Aventage RX-A3040
Page 182: ...2014 Yamaha Corporation YG260B0 EN...
