Yamaha Aventage RX-A3040, Owner'S Manual

Page: 45 / 182

PREPARATIONS
➤
Connecting the power cable
En
45
Connecting a device compatible with the trigger function
The trigger function can control an external device in conjunction with operating the
unit (such as powering on/off and input selection). If you have a Yamaha subwoofer that
supports a system connection or a device with a trigger input jack, you can use the
trigger function by connecting the external device to one of the TRIGGER OUT jacks.
• You can configure the trigger function settings in “Trigger Output1” and “Trigger Output2” (p.139) in the
“Setup” menu.
After all the connections are complete, connect the supplied power cable to the unit
and then to an AC wall outlet.
TRIGGER
OUT
1
2
12V 0.1AMAX. TOTAL
The unit (rear)
TRIGGER OUT
1–2 jacks
System
connection
input
Yamaha
subwoofer
Power amplifier
(such as MX-A5000)
Trigger In
(+12V)
7 Connecting the power cable
Before connecting the power cable (General model only)
Set the switch position of VOLTAGE SELECTOR according to your local voltage.
Voltages are AC 110–120/220–240 V, 50/60 Hz.
• Make sure you set VOLTAGE SELECTOR of the unit BEFORE plugging the power cable into an AC
wall outlet. Improper setting of VOLTAGE SELECTOR may cause damage to the unit and create a
potential fire hazard.
VOLTAGE SELECTOR
220V-
240V
110V-
120V
The unit (rear)
VOLTAGE SELECTOR
To an AC wall outlet
The unit (rear)
1 2 3 4 5 6 7 8 9 10