WARNING
Move carefully and smoothly when the load is raised
over a stack. When the load is elevated the center of
gravity of the lift truck and the load is much higher. The
lift truck can tip over when the load is raised.
5.
To put the load on a stack, align the lift truck with the
stack. Raise the load higher than the point where it will be
placed. Do not raise the load to a point below where the
load is to be placed and "jog" the load up into position. This
operation uses added energy. Be careful not to damage or
move adjacent loads.
IF THE LIFT TRUCK TIPS OVER EITHER TO THE SIDE
OR FORWARD, DO NOT JUMP OFF! HOLD FIRMLY TO
STEERING WHEEL, BRACE YOUR FEET, AND LEAN
FORWARD AND AWAY FROM THE POINT OF IMPACT.
Move forward slowly. When the load is in position, lower
the load on to the stack or the rack. Lower the forks just
enough to remove them from under the load. Do not lower
the forks so that they will drag on the surface under the
load. Tilt the mast forward just enough to permit smooth
removal of the forks from under the load. Carefully move
the lift truck backward to remove the forks from under the
load. Lower the forks when traveling.
Operating Procedures
97
Summary of Contents for VERACITOR GCC030VX
Page 24: ...Figure 6 Display Switch Cluster Right Side Display Inputs Model Description 22...
Page 40: ...Figure 8 Operator Controls Sheet 2 of 2 Model Description 38...
Page 83: ...Figure 13 Seat Adjustment Full Suspension Operating Procedures 81...
Page 172: ...Figure 43 LPG Tank and Bracket Maintenance 170...
