Service Brakes
Brake Fluid Level
WARNING
If the brake system has a power assist (or boost), brak-
ing will be more difficult if the engine is not running.
Loss of fluid from the brake fluid reservoir indicates a
leak. Repair the brake system before using the lift
truck. Replace the brake fluid in the system if there is
dirt, water, or oil in the system.
There is an indicator light on the Display Switch Cluster for
the brake fluid. The red light is
ON
when the key switch is
in the
START
position or the Power
ON/OFF
button is
pressed, and must go
OFF
when the engine is running. If
the light is
ON
when the engine is running, the brake fluid
level in the reservoir is too low.
Operation, Check
Check the operation of the service brakes. Push on the
inching/brake pedal. The service brakes must be applied
before the inching/brake pedal reaches the floor plate. The
pedal must stop firmly and must not move slowly down
after the brakes are applied. The service brakes must apply
equally to both drive wheels. The service brakes must not
pull the lift truck to either side of the direction of travel when
they are applied. The service brakes are automatically
adjusted when the transmission is in reverse and the lift
truck is moving and the brakes are firmly applied. Full appli-
cation of the inching/brake pedal applies the service brakes
and puts the transmission in
NEUTRAL
.
Lift trucks with a pedal:
when the inching/brake pedal is
fully applied, the engine can be started.
Maintenance
162
Summary of Contents for VERACITOR GCC030VX
Page 24: ...Figure 6 Display Switch Cluster Right Side Display Inputs Model Description 22...
Page 40: ...Figure 8 Operator Controls Sheet 2 of 2 Model Description 38...
Page 83: ...Figure 13 Seat Adjustment Full Suspension Operating Procedures 81...
Page 172: ...Figure 43 LPG Tank and Bracket Maintenance 170...
