Points for consideration
• In home-armed mode the Burglar PIR or door
contact is active while the home omit PIR or
door contact is idle. Therefore, if the Burglar
PIR or door contact is triggered, the alarm will
sound, while if the home omit PIR or door
contact is triggered, the alarm will not sound.
• If the PIR or door contact has been set to Entry
and triggered when the system is in full or
home-armed mode, the system will sound a
chime (if selected).
• If the PIR or door contact has been set to
Home Delay and triggered when Home armed
mode, the control unit will start an entry period.
• If the PIR or door contact has the Instant
attribute selected with the Burglar, Home Omit
or Home Delay modes an alarm will be started
instantly when the control unit is in entry mode
if the devices are triggered. Do not use this
attribute if there is any likelihood of persons
straying into the protected areas during the
entry period.
Multiple door contact wiring
More than one window and door can be
protected by a door contact using the HSA3090
door/window contact accessory kit. The contacts
must be wired to the internal extension terminal
block as shown:
17
PIR operation
The light does not flash normally when it is
sensing movement, unless the jumper is in the
On test position.
If the LED flashes, it indicates that it has either
been tampered with, or the battery is getting low
and needs replacing.
Further door contact programming
The door contact can be set to work in 6
different modes:
• Whether it is armed when the control unit is in
home or away armed condition.
• Whether it is omitted in home mode.
• Whether it is a fire alarm.
• Whether it is a 24-hour alarm.
• Whether it is installed as an entry point.
• Whether an alarm is started instantly or
delayed during the entry period.
These choices presented in the learning-in and
editing procedure and are summarised by these
codes:
B Burglar
Armed when in away or home
armed modes
O Home Omit Not active when in home armed
mode
D Home Delay Starts entry delay when in home
armed mode
F Fire
Activation will give a fire alarm
H 24-Hour
The door contact is active all the
time and will give a burglar alarm
E Entry
Control unit will start the entry
time when activated
I
Instant
Works with other modes and
starts an alarm instantly when
triggered in away arm entry
period. Not available with Entry,
Fire or 24-hour modes.
• Fire and 24-hour door contacts are active all the
time and do not have to be armed or disarmed.
Knockout
removed for
wire
Door/window
switches wired
in series
Magnets
