13
Arming the system
Away arming
1
Enter your PIN code and press OK.
2
Away Arm and Home Arm can be selected by
using the arrow keys, select Away Arm.
3
Press OK. The display will go blank and exit
delay counts down from the default setting of
10 seconds with a series of pips.
4
When the time is up, the control unit sounds a
long beep.
• The siren will beep once (if the siren confirm
has been switched on) and the strobe will flash
once after the exit delay has expired.
• You can also put the system into away arm
mode by using the keypad or keyfob accessory.
Home arming
1
Enter your PIN code and press OK.
2 Press
▼
to move the cursor down to select
Home Arm.
3
Press OK. The display will go blank and exit
delay counts down from the default setting of
10 seconds silently.
4
When the time is up, the control unit sounds 3
beeps.
• The siren will beep once (if the siren confirm
has been switched on) and the strobe will flash
once after the exit delay has expired.
• You can also put the system into home arm
mode by using the keypad or keyfob accessory.
Stopping the exit delay
Do this by disarming the system.
1
Press
a
and an Enter Code display will show
the exit seconds counting down.
2
Enter the PIN code.
3
Press OK.
Alarm off will be displayed and the system
returns to disarmed mode.
Disarming the system
1
Enter your PIN code.
2
Press OK. The control unit will beep twice and
disarm.
• The siren will beep once (if the siren confirm
has been switched on) and the strobe will flash
once after the exit delay has expired.
• You can also disarm the system by using the
keypad or keyfob accessory.
Alarm activation
If a sensor is triggered when armed, or if an
entry period is left to expire, the control unit will
activate the alarm immediately, while if a Home
Omit sensor is triggered, the control unit will not
respond if in home mode.
If a 24-hour alarm, fire alarm, personal attack,
alarm tamper or auxiliary alarm is triggered, the
control unit will activate the alarm immediately
irrespective of what alarm mode the control unit
is in.
During an alarm, the control unit will sound the
siren depending on the programmed options
chosen.
Stopping the alarm
1
Key in your PIN code, and then press OK.
The alarm and dialling will stop and the display
will show the device and zone which triggered
the alarm in the Alarm Log.
2
Press any key.
If an alarm is silenced using a remote keypad
or keyfob, the system will only silence the alarm -
not disarm the system. The system can only be
disarmed after an alarm event at the control
panel.
Tamper and low battery display
The control unit signal any device triggering a
tamper alarm or low battery warning by beeping
every 30 seconds when disarmed.
When any key is pressed a two-tone fault beep
will sound and the device causing the fault will be
displayed.
The display can be cleared when disarmed by
pressing OK if the fault has been remedied, if not
the display will be shown every time a key is
pressed. Keying in your PIN code while the fault
display is shown will allow arming and disarming
the system.
• Tamper and low battery warnings cannot be
cleared completely until the problem is
rectified.
Stopping the alarm
1
Key in your PIN code and press OK. The alarm
will stop and the display will show the device,
zone and name (if entered) that triggered the
alarm.
2
Press OK and the display will be cleared and
replaced with Alarm Off.
Arming and disarming
Arm and disarm the system and practice using it. Trigger the alarm by arming the system
and opening protected doors/windows and walking past PIR’s. Now is the time to show
the rest of the family how simple it is to use.
5
