12
either a low battery or a tamper condition. In
the event of a low battery, replace the
exhausted batteries with fresh alkaline
replacements.
• Do not position a PIR to look directly at a door
protected by a door contact, this could cause
the door contact and PIR radio signals to be
transmitted at the same instant when entering,
cancelling each other out.
• Ensure the jumper is in the normal ‘off’ position
when testing is finished, otherwise the low
battery and tamper conditions will not be
shown.
Door/window contact
1
Ensure that the jumper is in the test ‘on’
position.
• In this position the indicator light will illuminate
every time the door contact is operated.
2
Fit as described
under alternative
mounting methods,
mounting the
detector base on the
frame and aligning
the magnet by the
arrow as shown.
• The magnet should
not be more than
10mm from the
detector when the
door is closed.
• Ensure the tamper
switch spring is
positioned so that it
makes contact with the mounting surface
through the tamper switch aperture.
• If the door contact cannot be mounted on the
doorframe, use the HSA3090 kit with a length
of wire to mount the door contact remotely.
• When fitting to a window, fix the magnet to the
moving part and the detector to the frame.
3
Fix the detector on its base and secure with
screw. Test it by opening and closing the door
or window. The light will flash when an open
condition is detected.
4
Remove the detector, put the jumper in the
normal ‘off’ position. Screw the detector back
onto its base.
• When the jumper is in the normal ‘off’ position
the indicator light will normally be off. It will
only light if there is a problem, either a low
battery or a tamper condition.
• Ensure that the jumper is in the normal ‘off’
position when testing is finished, otherwise low
battery and tamper conditions will not be
shown.
Siren
WARNING: The siren is
extremely loud!
The tamper switch
plunger protrudes through
the back of the unit, so
that if the siren is pulled
from the wall the alarm is
activated. Ensure that it is
fully depressed when the
siren is mounted. If there
is a gap, pack with a
suitable spacing material.
1
Find a suitable location,
where it is clearly
visible and out of reach.
2
Disable the tamper
switch by selecting
Program Siren, then
Siren A/T Off and
press OK.
3
Using the large screws
provided, mount on
the wall through the
base plate mounting
holes shown.
4
Fix the siren cover
with the securing
screw.
5
Enable tamper switch by selecting Program
Siren menu on the control unit, then Siren A/T
On and press OK.
6
Test by arming and disarming with the control
unit. If 5 pips sound the tamper switch is not
correctly set.
Installation is complete.
Remote keypad accessory
Mount as described under screw mounting.
Smoke alarm accessory
Mount as described under screw mounting.
Help button accessory
Mount as described under screw mounting.
Door/
Window
Frame
Align
8mm (max)
Tamper switch plunger
must be pressed in fully by
wall surface
Fixing holes x 4
