9
Add the door/window contact
1
Select D/- by scrolling down the menus
and press OK.
2
Select the Add Device menu and press OK.
3
Press the learn button
in the back of the door
contact.
4
The door contact will
be detected and the
device type displayed.
5
Press OK.
6
You are prompted to
select a working
mode.
• Each device is automatically given a zone
number for identification purposes.
• The PIR can be set to work in other different
modes (see later in the programming section),
for now we will assume it is being used to
protect the point of entry. This will start an
entry time countdown when the system is
armed and the entry door is opened.
7
Select Entry from the list displayed and press
OK.
8
Select instant off and press OK.
9
When the Enter zone NAME menu is displayed
press OK without entering text.
10
The display will then show all the programmed
settings: DC Zone01 EC, Press OK and the
device will be installed.
11
Press OK.
• Press
a
to return to a previous menu.
• To return to Alarm off in normal mode, keep
pressing
a
repeatedly.
Add the siren unit
WARNING
The siren is very
loud, be prepared!
Take
care not to activate the
siren tamper switch
unnecessarily.
The siren is
programmed by the
jumper switches in the
left hand compartment.
1
Lift off jumper 1 and park it. The siren will beep
and flash. The siren is now in learn mode.
2
Lift off jumper 5 and park it. This must be left in
the ‘off’ position permanently.
• If jumper 3 and jumper 4 are removed during
the learning-in process, the siren will only be
activated for 1 second if accidentally activated
and is useful for testing. Ensure they are
replaced in their chosen positions before
replacing the covers.
3
Program the control unit by selecting /-
menu, then Program Siren menu, then Learn
siren.
4
Press OK and the unit will give a long beep to
confirm – the siren will also respond by a beep
and a flash.
5
Replace jumper 1 to the ‘on’ position, the siren
will beep and flash to confirm.
6
Disable the siren tamper switch by selecting
Siren A/T off and press OK.
• The siren tamper disable will automatically
revert to on after about an hour if not switched
back on again manually by selecting Siren A/T
On.
• Press
a
to return to a previous menu.
• To return to Alarm off in normal mode, keep
pressing
a
repeatedly.
Further siren programming
The siren can be further programmed if
required.
Siren jumper programming
Learn/
Test
button
Extension terminals
