19
Remote keypad
Programming
1
Learn-in as described by putting the control unit
into learn mode.
2
Enter 0000 on the keypad then press TEST. The
Tx LED will flash.
3
Press Test then 1 on the keypad when
requested. The keypad and control unit will
beep.
4
The display will show that a remote keypad has
been detected.
5
The control unit will ask for a name to be
entered (described in device naming), either
enter a name and press OK, or just press OK
for no name.
6
The display will show you the successfully
added device.
7
Press OK, the addition of a new device is
complete.
PIN code
1
Put the keypad into programming mode by
entering the factory set code 0000 and pressing
TEST.
2
Enter 0000 then press CLR.
3
Enter the new 4 digit code and press PROG.
The keypad will beep in response.
4
Press OFF twice to exit programming mode.
• It is advisable to use the same PIN code as one
of the control unit codes, but it can be different.
Help button
Program your help button before installation
and test in the desired location before mounting.
Programming
1
Learn-in as described by putting the control unit
into learn mode.
2
Press the button when requested for at least 3
seconds.
3
The display will show that a Help Button has
been detected.
4
Press OK.
5
The control unit will ask for a name to be
entered (described in device naming), either
enter a name and press OK, or just press OK
for no name.
6
The display will show you the successfully
added device.
7
Press OK, the addition of a new device is
complete.
Using
To activate, press and hold the red button for at
least 2 seconds – LED will light momentarily and
the alarm will be activated.
To silence an alarm, press and hold down the
red button, after 10 seconds the LED will light
momentarily for a second time – alarm will be
silenced.
• Please note that silencing the alarm with the
help button does not reset the system. If the
alarm is armed prior to activation, the system
will re-arm after being silenced with the help
button.
Smoke detector
Programming
1
Learn-in as described by putting the control unit
into learn mode.
2
Press the button when requested and the
smoke detector will give a two tone beep.
3
The display will show that a smoke detector
has been detected.
4
Press OK.
5
The control unit will ask for a name to be
entered (described in device naming), either
enter a name and press OK, or just press OK
for no name.
6
The display will show you the successfully
added device.
Press OK, the addition of a new device is
complete.
Using
• The smoke detector has an internal siren and a
light to indicate a fire alarm, in addition to
triggering the control unit.
• The smoke detector can be walk tested by
pressing the test button without using smoke.
Ensure that the control unit is put into walk test
mode first before testing.
• The smoke detector has a self-test feature; if
everything is OK then the detector will produce
a two-tone beep when the test button is
pressed, if three pips are heard the detector is
faulty.
• The smoke detector will trigger the control unit
repeatedly when activated, to silence the
smoke detector and prevent the control unit
being re-triggered for 10 minutes the test
button should be pressed when in alarm.
