29
Setting the speaker mute
You can mute the audio output of the speaker of the node station FT3D/FT2D transceiver.
You cannot set it in Direct Operation.
Press [
A/B
] key each time toggles the mute mode as follows.
MUTE OFF
MUTE ALL
MUTE TX
MUTE RX
MUTE OFF
・・・
MUTE OFF
: Disable mute.
MUTE ALL
: Mute both the received voice from the C4FM digital station and the voice from the node station on the
Internet.
MUTE RX
:
Mute the received voice from the C4FM digital station.
MUTE TX
:
Mute the voice from the node station on the Internet.
When the MUTE setting is enabled, the mute icon “ ” blinks at the top of the LCD.
When the frequency setting screen is displayed, the mute setting status is displayed for about 1 second on the screen
each time you press the [
A/B
] key.
FTM-400XD/D
1. Press the [
DX
] key on the portable node FTM-400XD/D transceiver.
The “
X
” icon flashes on the upper left of the LCD screen.
• The display screen example shows the “
Access Point
” screen. In “
Direct Operation
”,
“
DIRECT
” is displayed instead of the frequency
• If the “
X
” icon does not blink when the [
DX
] key is pressed, communication between the
transceiver connected to the PC and the WIRES-X software has not been established, so
check the cable connection and USB driver installation.
• To cancel the connection, press and hold the [
DX
] key.
2 & 0
Ჸ Ჸ
᳀ Ჾ Ჸ
Ჽ Ჸ Ჸ
6 1 - ; 1 Ჺ
/ 76'
5%12'
/
8
5 3 .
2. When the operation of the portable node is started, the “
X
” icon changes from blinking
to lit and the Node ID and the city of its own station are displayed.
Depending on the history of the previously connected node on the Internet and the
current connection status of the portable node, one of the following three screens is
displayed.
If the portable node is not connected to a node or a room on the Internet
①
When connection history is not stored
The lower connection destination display will be blank.
Ჸ Ჸ
/ 76'
5%12'
/
8
5 3 .
; # ' 5 7 6 5 7 4 +
5*+0#)#9#-7
, 3 ; $ ( 6 +
+ & 6 4 :
②
When connection history is stored
The ID of the previous connected Node or Room will display in gray.
Press the
PTT
switch or touch [
connection ID
] to connect.
Upon being connected, the text will light up in white.
Ჸ Ჸ
/ 76'
5%12'
/
8
5 3 .
; # ' 5 7 6 5 7 4 +
5*+0#)#9#-7
, 3 ; $ ( 6 +
; # ' 5 7 6 7 4 +
+ & 6 4 :
