22
Setting the transceiver (Access Point only)
When using the “
Access Point
", it is necessary to set the node station transceiver parameters, such as operating fre-
quency and DG-ID number on the portable node station transceiver.
When using the “
Direct Operation”,
it is not necessary to set the frequency and parameters on the transceiver, just
proceed to “
Start operation of Portable Node
” (page 27).
1. To set the operating frequency:
Use the transceiver
DIAL
knob, the Numeric keypad input screen, or the memory channel to set the operating frequency.
In the
“Transceiver Setting Screen
”, the portable Access Point function is not working. You may communicate
normally with C4FM digital mode (DN mode only) with the transceiver.
FT3D/FT2D
On the frequency setting screen, you can set and operate the following with the transceivers key and
DIAL
knob settings.
Function
Key or Dial
Switches between the Access Point and the Direct Operation Press the A/B key
Starts operation for the Portable Digital Node
Press the X key
Sets the operation frequency
Rotate the DIAL knob or press the Numeric keypad
input screen
Switches between the VFO mode and the Memory
Channel mode
Press the V/M key
Moves operation to the next-highest frequency band
Press the BAND key
Sets the transmit and receive DG-ID number
Press and hold the GM key
TX/BUSY LED turn OFF/ON
V/M key (Press and hold)
Enters the Set mode*
Press and hold the DISP key
Enters the BACKTRACK screen
Press the DISP key
Registering to Memory Channel
Touch and hold [F MW]
Displays the Function Menu Screen
Touch [F MW]
Selects the Transmission Power Level
Touch [TX PWR] on the Function Menu Screen
Recalls the “HOME” channel
Touch [HOME] on the Function Menu Screen
Reverses the transmit and receive frequencies
Touch [REV] on the Function Menu Screen
Squelch OFF
While MONI key is pressed
Adjusts the squelch level
Press the SQL key, then rotate the DIAL knob
Switches Busy detection between “Noise squelch” and
“DG-ID number match”.
Press and hold the A/B key
* Some setting items in the set mode are automatically set for the Portable Digital Node function, so these
settings cannot be used.
FTM-400XD/D
On the frequency setting screen, you can set and operate the following with the transceivers key and
DIAL
knob settings.
Function
Key or Dial
Switches between the Access Point and the Direct Operation Press the Band B DIAL knob (Lower)
Starts operation for the Portable Digital Node
Press the DX key or press the P3 key on the micro-
phone (by default setting)
Sets the operation frequency
Rotate the DIAL knob or press the numeric keypad
input screen
Switches between the VFO mode and the Memory
Channel mode
Touch [V/M] on the LCD screen
Sets the transmit and receive DG-ID number
Press and hold the GM key
