8
Check the LAN for installing the transceiver
As it will be necessary for installation, check the "network environment" of the LAN where the remote control
radio is actually installed by following the steps below:
It is not necessary to connect SCU-LAN10 to the network for this confirmation procedure.
Three connection examples are explained below, refer to the explanation that applies to your installation.
(1) For remote control via Internet
When connecting via the Internet, refer to the diagram and check the four designated items.
WAN
Modem
LAN
Router
SCU-LAN10
PC
Other network device
Internet
Global fixed IP address or
fixed domain name
IP address of the router
IP Address
Subnet mask
Check the following settings by referring to the instruction manual of your router or other network device.
Generally, for setting routers and network devices, use a web browser such as Internet Explorer to access
the IP address of the router or network device and display the setting screen.
Global fixed IP address or fixed domain name on the WAN side of the router
When performing remote control via the Internet, apply in advance to an Internet service provider to ob-
tain a global fixed IP address, or use various DDNS (Dynamic Domain Name System) services to obtain
a fixed domain name. When using DDNS, it may be necessary to set the DDNS settings automatically
when the dynamic IP address is changed.
IP address of the router
Example:192.168.0.1, etc
Subnet mask
Example: 255.255.255.0, 255.255.0.0, etc.
IP addresses of other devices (other computers, network cameras, etc.) connected to the same router*
If there is a device with the same IP address as SCU-LAN10 in the same network, it will not operate
normally.
Example: 192.168.0.2, 192.168.0.3, etc
*Sharing the network with other devices may cause remote control or audio delay, so it is recommended
that you do not connect other devices as much as possible.
