13
Preparation for initial setting
Connect device
For initial setting, refer to the figure and connect the PC and the SCU-LAN10 directly with a commercially
available straight Ethernet cable.
z
It is recommended to connect the PC and SCU-LAN10 directly with an Ethernet cable as shown in the figure without using
a router for the initial setting.
z
Initial settings cannot be made via the Internet, so make initial settings before installing the transceiver and SCU-LAN10.
1. Turn the transceiver
OFF
.
2.
Refer to the figure and connect the SCU-LAN10 directly to your computer with a commercially available
straight Ethernet cable.
3. Connect the SCU-LAN10 and FTDX101MP / D with the included ACC cable and USB cable.
ANT 1
ANT 2
EXT SPKR
KEY
ACC
TUNER
PTT
METER
GND
LINEAR
+13.8V
REM
EXT ALC
RS-232C
A
B
Commercially available straight Ethernet cable
LAN
LAN
ACC
ACC
SCU-LAN10
(Factory default settings)
IP address: 192.168.49.1
User: defaultuser
Password: defaultuser
Network settings of PC used for initial setting (example)
IP address: 192.168.49.10
Subnet mask: 255.255.255.0
Use the cable ties (accessories) to secure the
two ferrite cores (accessories) to the bases of
the plugs on both ends of the ACC cable.
