7
SCU-LAN10
Front panel
POWER indicator
Flashes or lights green when the power is on.
STATUS indicator
In addition to the POWER indicator, various statuses of this unit are displayed.
When main power is supplied to the transceiver, the SCU-LAN10 will start up and enter the standby state.
The STATUS indicator (red) starts blinking ∙∙∙∙∙∙ SCU-LAN10 start up
POWER indicator (green) blinks (after about 12 seconds) ∙∙∙∙∙∙ SCU-LAN10 standby
POWER indicator (green) lights up ∙∙∙∙∙∙ Remote control connected
RESET switch
When the power is ON, press and hold until the STAUS indicator (red) blinks with a thin object (about 5
seconds), and all the settings of this unit will return to the factory default.
Do not push the RESET switch too hard.
Rear panel
AUDIO IN/OUT (3.5Φ stero) jack
(
Not normally used)*.
This jack is for the output of receive audio and input of (100 mVrms @600Ω).
ACC connector
Connect to the transceiver with the included connection cable (13pin DIN connector).
RS-232C connector*
LAN connector
Use a commercially available straight LAN cable (category 5e or higher) to connect to the LAN.
USB connector
Connect to the transceiver with the included USB cable.
DC-IN*
External power connector. (DC 10.5 V max 800mA)
* For future expansion. It is not used with the FTDX101D/FTDX101MP.
