P12
P12
2. Tap “PLA Test Page" to print. 3. Wait for the extruder to heat
up to operating temperature.
1. You can also choose to print
the "PLA Test Page" to confirm
the ink status.
6. Taken off the printing object
and check the coloring status.
4. Printing "PLA Test Page".
5. Confirm if the print job is
completed.
Function Operation and Instructions
We suggest you print a test page after you install the ink cartridge. Please prepare a sheet of paper.
2. Tap Test Page.
3
. Test Page.
1. Tap Calibration.
9. Remove the test page and
tap PROCEED.
Calibration
Test Page
Ink
Paper Test Page
C2-1
8. Fix the paper onto the print
bed and then tap PROCEED,
the printer will do a test print.
6. Fold tightly the excess A4 paper to the back of the rubber
magnet.
5. Tighten/pull the A4 paper so
it is flat(no gap) on the rubber
magnet.
4. Take out the EZ Removable
Rubber Magnet. Use tape to
secure the A4 in the portrait
direction on the front side of the
rubber magnet.
7. Put the rubber magnet back
to print bed accordingly.
Calibration
Test Page
Ink
PLA Test Page
C2-1
