P 25
V.1.1
da Vinci 1.0 Pro 3in1
Laser engraver module must be purchased separately.Please read through this manual
and all safety reminders carefully before using, operating, dismantling,replacing,
or removing this product. Please also comply with relevant safety reminders and
instructions.
Note: Avoid using materials that are light colored, white, or have glossy surfaces for laser engraving.
Achieve the best engraving results with gray colored or dark colored materials.
Plastic materials (such as PP / ABS / PE) may be engraved. However, please avoid using materials
that are transparent, white, or lightly colored.
The engraving module is only capable of engraving planar objects. The target should thus be
placed flatly on the panel. Avoid engraving warped or curved objects that are not completely flat.
Recommended laser engraving material:
Replace and Installing the laser engraving module:
Functions of the laser engraving software:
◆
Paper
◆
Cardboard
◆
Leather
◆
Wood
◆
Plastic
Before replacing the extruder module with the laser engraving module, check if there are remaining filaments in
the nozzle and remove them accordingly. After removing the filament, please select [CHANGE NOZZLE].
Once the laser engraver module has been installed, open the “XYZware Pro” software. Select the laser en-
graving function located at the upper right of the toolbar. Import the picture file to be engraved, edit and set
laser engraving effects, and initiate the engraving process.
◆
Wait for the panel to display the message that allows you to switch off the power to replace the printing module
before switching off the power.
◆
Unplug the heating bus at the side of the extruder module.
◆
Pull open the quick-detachment lock to release the extruder module. Tilt the module and remove it from the slot.
◆
Install the laser engraver module. Please ensure that the module has been oriented in the correct direction, then
connect the heating bus cables.
◆
Pull the quick-detachment button. Tilt the laser engraving module and insert it into the installation slot.
◆
Press the quick-detachment button and ensure that the module is secured by the locking lever at the correct
position to complete the installation.
◆
Installation / detachment of the laser engraving module completed. Provide proper safekeeping of the extruder.
●
●
●
Product Overview
●
Engraver
head
Heating bus slot
Fan
Select module
