Revision 1.1
WebSwitch™ Users Manual
Filter Logged Requests
When logging is enabled for XML Requests, Modbus Requests, or SNMP Requests, the user can
filter out
Reads
(such as reading the outlet or input state via an XML request) or
Writes
(such as
changing the outlet state via an XML command).
On the Control Page Setup tab, the user can specify the refresh rate of the Control Page. Each time
the page is refreshed, an XML request is sent and logged as a Read. Since the default refresh rate
is 3 seconds, the log file can get cluttered by many XML request logs. By selecting Reads, those
XML requests will not be shown in the log. Likewise, by selecting Writes, any log created by
changing the state of the relay will not be shown in the log file. Default selection is None.
Note: When XML Requests are setup to be logged, the IP address from which the Read or Write is
generated is logged, as well as if it was a Read request (R) or Write request (W). See Appendix E:
Log Files for additional information.
Next Log Time
This field displays the next periodic log time. If logging is disabled, the next log time will indicate
"Disabled." If logging is enabled, but periodic logging is disabled (by selecting
Event Logging Only
)
the next log time will indicate "Event Logging Only."
Note: This information is updated only when the page is refreshed.
Xytronix Research & Design, Inc.
43
