Revision 1.1
WebSwitch™ Users Manual
Appendix F: SNMP Requests, Objects and Community Strings
Outlet states, input states, some simple network parameters, and temperature/humidity measured by
WebSwitch™ can be retrieved using SNMP. The states of the outlets can also be changed through
SNMP SET requests when the device is configured correctly. For most cases, using SNMP is as simple
as locating the appropriate MIB files and loading them into the SNMP manager software. Once the MIB
files have been loaded, information from WebSwitch™ can be accessed. WebSwitch™ can make use of
the following MIB files: RFC1213-MIB, and XYTRONIX_V1_0.mib.
Note: As new MIB file become available with support for other products, the older MIB files can be safely
overwritten.
WebSwitch™ supports the following requests:
━
GET
━
GET NEXT
━
WALK
━
SET
WebSwitch™ also supports a few objects found in MIB for network management of TCP/IP-based
internets. The MIB for these objects usually come with SNMP manager software. If it does not, an
internet search for RFC1213-MIB will turn up multiple links for this MIB. The following objects are
supported from this MIB. All of them are read only.
Standard Objects
RFC1213 Object
Response
system.sysDescr
WebSwitch - Automatic Reboot Controller
system.sysObjectID
WebSwitch
system.sysUpTime
Time in hundredths of seconds since WebSwitch™
was last powered
system.sysName
WebSwitch*
*The sysName is customizable under the
Control Page Setup
tab.
Xytronix Objects
WebSwitch™ also supports some special objects that can be found in the MIB XYTRONIX_V1_0.mib.
This MIB can be downloaded from our website. The following objects are supported from this MIB. Some
are read only, while others have read/write capability.
Read Only Objects:
Inputs (Model XRDI-WS3P only)
Object
Input Type
Response
webswitch_inputOne
Digital
Value: 0 or 1 (0 - OFF, 1 - ON)
webswitch_inputTwo
Digital
Value: 0 or 1
Xytronix Research & Design, Inc.
95
