Operation Manual
35
www.xmfg.com
Operator Cab
Display Indicators
The display allows the operator to view vital engine
information and other critical functions, including gauge
display, engine diagnostics to monitor engine condition and
performance, fault codes, and warning indicators.
Fig 24. Display Indicators
N
E
A
B
C
D
G
H
I
L
Q
M
F
K
J
A. TURN SIGNAL
The corresponding left or right arrow blinks when the turn
signal switch is operated. Both arrows blink when the hazard
switch is enabled. (Fig. 21).
B. STEERING AXLE POSITION
The Axle Position Indicator illuminates and displays "Axle Cen-
ter" when the rear wheels are aligned perpendicular to the
rear axle. The rear wheels should be centered before chang-
ing steering modes.
The Axle Position Indicator illuminates and displays "Axle
Lock" when the Telehandler is in the axle lock mode. The rear
axle locks when the parking brake is set to ON (engaged), or
the transmission is in NEUTRAL or the service brake is applied,
and when the boom is above 100. If the "Axle Lock" Indicator
does not illuminate when the Telehandler is in the axle lock
mode, stop the Telehandler, follow proper shut down proce-
dures, tag Telehandler with “Do Not Operate” tags, and have a
qualified mechanic service or repair the Telehandler BEFORE
placing it into service again.
C. HIGH HYDRAULIC OIL TEMPERATURE
The hydraulic oil temperature indicator illuminates when the
oil temperature is above 1800 F. If the hydraulic oil tempera-
ture indicator illuminates, stop and idle the engine to allow
time for cooling. If the hydraulic oil temperature indicator
does not go out after five (5) minutes, stop the forklift, follow
proper shut down procedures, tag the forklift with "Do Not
Operate" tags, and have a qualified mechanic service or repair
the forklift BEFORE placing it into service again.
D. WATER IN FUEL
The Water in Fuel Indicator will be displayed when water is
detected in the fuel filter. Drain the water by opening the pet-
cock on the bottom of the fuel filter.
If there is no alert, the top row indicators disappear.
E. PARKING BRAKE
The Parking Brake Indicator will be displayed when the park-
ing brake is applied.
F. OIL PRESSURE
The Oil Pressure Indicator will be displayed when the engine
oil pressure is below normal. If the Oil Pressure Indicator
comes on during normal operation, stop the forklift, follow
proper shut down procedures, tag forklift with “Do Not Oper-
ate” tags, and have a qualified mechanic service or repair the
forklift BEFORE placing it into service again.
NOTE: The indicator at position G has more than one function
as described below. Refer to the Operation section on Warn-
ing Indicators.
G. WAIT TO START
The Wait to Start Indicator is displayed when the key
switch is moved to the RUN position. Wait until the
indicator goes out before starting the engine.
G. GENERAL WARNING
After the engine is started, the Wait To Start Indica-
tor goes out. It is replaced by a Warning Indicator
which is displayed when there's a general warning. When the
Warning Indicator comes on, a description of the warning is
displayed on the Message Display at position N (instead of the
digital clock showing).
G. ENGINE STOP
The Engine Stop Indicator is displayed when the
engine is shut down. It is displayed with a flashing
Check Engine Indicator when an engine shutdown is immi-
nent. The Engine Stop Indicator will be displayed when there
is a serious engine fault and the engine should be shut down.
H. ENGINE SERVICE REQUIRED
The Engine Service Required Indicator will be displayed when
a maintenance interval has been exceeded.
I. BACK-UP CAMERA
Optional equipment.
J. ENGINE LOAD
Displays the percent of rated load for the current engine RPM
that is being applied to the engine.
O
P
R
S