User Manual
XProHeli Silk Gimbal
Silk Gimbal
Page 35
©2014 XPROHELI. All Rights Reserved.
ii. Advanced Tab – More precise tuning options – for fine
tuning you should not need to adjust any of these
parameters.
iii. RC Settings – Settings to control the gimbal roll/pitch/yaw
orientation with RC inputs.
iv. Service – Specify the behavior of the MENU button
(located on the bottom of the control box) and tune the
battery monitoring service.
v. Follow Mode – Settings related to this special mode of
camera control.
vi. Realtime Data – Realtime sensor data monitoring. This
screen is helpful in tuning your gimbal performance.
vii. Firmware Upgrade – Firmware and SimpleBGC GUI
software versions and update options.
Upgrade firmware at
your own risk!
4. Control Panel – Graphic visualization of gimbal orientation angles
for all three axes.
• Black arrows display the angles.
• Blue arrows are a 10x time magnification to provide higher
precision.
• Red marks show target angles that the gimbal should hold.
• Thin blue lines show the peak deflection from the central,
neutral point. Blue digits show peak deflection amplitude,
which provides an estimation of stabilization quality.
• Vertical red bars to the right of the scales show actual
power level from 0 to 100%.
5. READ, WRITE, USE DEFAULTS buttons are used to transfer settings
to/from the controller board.
*NOTE: USE DEFAULTS BUTTON WILL OVERWRITE ALL SILK
SETTINGS*
6. MOTORS ON/OFF button – manually turn on/off power to motors.
