User Manual
XProHeli Silk Gimbal
Silk Gimbal
Page 15
©2014 XPROHELI. All Rights Reserved.
Mount Silk to Landing Gear/Stand
Remove the Silk from the case and cut any zip ties holding the
frame in place from shipment.
Rest the top plate of the Silk on top of the stand so the two center
holes align.
Fasten the top plate with (2) ¼-20 x ½” long stainless fasteners
provided (5/32” hex tool) through the top plate of the Silk and
screw into the pressed in pem nuts of the Silk stand.
Depending on your mounting preference or mode of operation
with the Silk (i.e. 2
nd
operator) you also have the option of mounting
the gimbal to the stand using the lower plate as shown below. This
plate is also used to ‘rest’ the gimbal on the stand when used for
handheld operation.
Built in
¼-20 Pem Nuts
Mount Gimbal
with provided ¼-
20 5/32” Hex
Note Forward
direction of Plate