User Manual
XProHeli DYS 3XBrushless Gimbal
DYS 3X Brushless Gimbal For GoPro
Page 28
©2014 XPROHELI. All Rights Reserved.
Tilt control setup for DX8 Radio
Typically tilt control on the DYS gimbal for single
operator setups is programmed on Aux3 of your DX8 /
AR8000 radio. To control the tilt a servo signal wire will
connect from your AR8000 receiver directly to the back
of your gimbal on the RC_PITCH control input pins (see
picture above pg 25.)
We typically setup the 3-position FLAP switch on the
DX8 to control the tilt of the camera. Top position is
typically close to 0 degrees facing forward, middle
position is about 45 degrees down and bottom position
is full 90 degree tilt.
Here are the radio and software settings:
RC Settings Tab (PITCH):
Travel Settings:
