User Manual
XProHeli DYS 3XBrushless Gimbal
DYS 3X Brushless Gimbal For GoPro
Page 4
©2014 XPROHELI. All Rights Reserved.
2.
QUICK START
Overview
The DYS 3X is configured and custom tuned by XProHeli with the
addition of a custom soldered mode button to access different
features in the software. Setup of this gimbal is done in a few steps,
mounting the gimbal, installing the camera and finally powering
the unit on.
Please take care in unpacking the contents and be conciencious
of how you handle the gimbal. Gimbals are not yet bullet proof so
be careful not to snag a loose wire or neglect the gimbal. Water
will damage the gimbal as will lots of dirt / debris.
Never power the gimbal with any power source other than a 3S
rated voltage (11.1 – 12.5 volts). Doing so will ruin the control board.
Specifications
Supported Camera:
GoPro Hero 3/3+
Weight:
238g (316g with GoPro Hero 3)
Working Rotation Range:
Tilt Axis: +-90
o
Roll Axis: +- 40
o
Yaw Axis: +- 270
o
Input Power:
3 S (11.1V)
Software Requirements:
Windows XP, Vista/7/8, Mac OSX
Motors:
Brushless, rewound 14 poles
Run-Time:
45 min (800mA battery)
100% Tested & Configured in Bend, OR USA
Important!
Never power up
your DYS 3X gimbal
without your GoPro
mounted to it!
Doing so can cause
damage.
