XO FLOW – Installation instructions
21
5.2.5
Alignment of the supporting leg
When the unit stand is plumb, adjustment of the supporting leg and the chair lift can be performed!
Please note that the supporting leg and the chair lift can be adjusted independently of the unit stand.
Figure 21 – Adjustment of the chair lift
1.
Place the spirit level on the chair lift post as shown in Figure 21.
2.
The chair lift is adjusted by turning the adjustment bushing in the supporting leg. See Figure 22.
Use the special wrench (MG-416) for this adjustment.
3.
When the chair lift is plumb, re-tighten the screw in the center of the adjustment bushing.
Figure 22 – Adjustment of the supporting leg