![background image](http://html1.mh-extra.com/html/xilinx/kria-k26-som/kria-k26-som_design-manual_3372861028.webp)
Table 7: K26 SOM PCB Signal Delays by I/O Bank
I/O Bank
Minimum Delay (Inches)
Maximum Delay (Inches)
MIO bank 501
1.53
2.02
MIO bank 502
1.36
2.05
HDA
1.48
2.05
HDB
1.74
2.02
HDC
1.72
2.49
HPA
1.49
1.89
HPB
2.13
2.87
HPC
1.21
2.04
SOM I/O Drive Strength Definition
For up to eight inches of trace length on the carrier card, the recommendation is to use a 4 mA
drive strength and a slow slew rate for all MIO and HDIO signals. When trace lengths on the
carrier card are longer than eight inches, signal integrity simulations might be necessary to select
the correct drive strength and proper termination.
RECOMMENDED: For MIO signals that are local to the SOM on MIO bank 500 and part of MIO bank
501, the recommendation is to use a 4 mA drive strength and slow slew rate.
For I/O modeling, including drive strength settings, the Zynq Ult MPSoC
be downloaded from the Xilinx website.
SOM Configuration and Control Signals
This section outlines the configuration and control signals associated with managing the Zynq
Ult MPSoC SOM.
Power-on Reset (PS_POR_B) Signal
This is the Zynq Ult MPSoC power-on reset signal. In Xilinx documentation this signal is
also described as PS_POR_B. The POR_B signal is an active-Low signal that must be asserted
during the SOM power-up sequence.
System Reset (PS_SRST_B) Signal
This system reset is primarily used for debug activities and is functionally equivalent to POR_B
except for clearing a subset of PS power-on and error registers. See the Zynq Ult Device
Technical Reference Manual (
) for more information.
Chapter 2: Electrical Design Considerations
UG1091 (v1.0) April 20, 2021
Carrier Card Design for Kria SOM
28