Xicom XTU-400K, Operation And Installation Manual

Page: 95 / 189

MNC-0400-001 35 of 54 Revision G
Operation, Rack and Digital HPAs
Configure COM2 Menu
Three softkeys are active:
[Softkey 1]— Sets the serial port baud rate. Cycles one step
each time the [Softkey 1] is pressed. The step sequence is:
[Softkey 2]— Sets parity. Cycles one step each time [Softkey 2]
key is pressed. The step sequence is:
None Even Odd None etc.
[Softkey 3]— Sets the data stop bits. Toggles between 8/1 and 7/
2.
Press Enter to return to Menu 4.
Set System Address
One soft key is active. Refer to Figure 14.
[Softkey 1]— Not used.
[Softkey 2]— Not used. Value to the left of this key shows current
address.
[Softkey 3]— Not used. Value to the left of this key is the new
address you enter using the numeric keypad. [ Enter ] accepts
the value. [ Clear ] clears the line.
[Softkey 4]— Return to Setup Menu 4.
Figure 14, Address Menu
1200 2400 4800 9600 19.2 38.4 57.6 1200,
etc.