Xicom XTU-400K, Operation And Installation Manual

Page: 105 / 189

MNC-0400-001 45 of 54 Revision G
Operation, Rack and Digital HPAs
Initial Setup and Operation
General
The amplifier can be operated from the amplifier Front Panel
(LOCAL configuration) or from a remote controller (REMOTE
configuration). The amplifier is configured at the factory with the
default values shown in Table 5. These values allow immediate
operation of the amplifier when the amplifier is connected to an
operational load or a dummy load capable of dissipating rated
RF output power.
Note
It is recommended that operating time (standby and beam-on),
operating conditions, power level, and maintenance actions be
Table 5, Default Values
Parameter Default Value
Gain Minimum Gain
Local/Remote LOCAL
RF Inhibit OFF
System Offset 0.0 dB
Max Power Trip OFF
Min Power Trip OFF
Max Reflected
Power OFF
Audio Alarm ON
COM1 9600 Baud, None, 8/1
COM2 9600 Baud, None, 8/1
Constant Power OFF
Heater Standby ON
HV ON at Startup OFF
Enable Key ON
Power Units dBW
Temperature Scale Centigrade